RACK IN MOTION

UNDERTAIL & MARKER LIGHT

COMBO KIT

FOR T-REX OR G2

Thanks You for purchasing this product, we are convinced it will give you complete satisfaction, here are instructions to help you installing the RIM T-rex Combo Led light on your T-rex or G2, we take for granted that you've worked on a bike before and you've dismantled your T-rex before, if, for some reasons the instructions below look strange to you don't do it, have a dealer or a friend do it for you, one that did it before of course.

TREXX SIDE MARKER LED

1. Remove the stock red lens on each side and disconnect the wire.

 

2. Connect the wire with your position light, Trexx comes with 3 wires, It mean you can use an running light and brake light or running and flashing light. Use the Male-Female plug supply in the kit to connect the wire.

3. Place the Trexx side led in place and mark the 4 holes with a marker, with a drill bit 1/4 drill those 4 Holes gently, use the plastic rivet lock to secure the ABS Trexx in place.

UNDERTAIL LED

1. Remove the stock Tail light assembly on your T-rex or G2

2. Cut the tail light support on the frame, use gently in the welding. after with a grinder smooth the edge of the frame to prevent cut and injury.

 

3. Use the Female plug supply in the kit to connect the wire on your machine, look at the Undertail Connector, You have

Brake application

Ground / running / brake

Back Up Light

Ground / light

Turn signal application

Ground Left and Right

Left Turn Light

Right Turn Light

Led Light for licence plate

Ground / Light

 

3. You will have to unscrew the Tail section to back it up a few inch, it will allow you space to slide the new ABS Undertail in Place, you will drill 4 holes of 1/4 to secure the Tail section, you have in the supply kit, 4 plastic rivet lock, or 4 rubber well nut with screw to old it in place, your choice. after you can slide the tail section back in place.

4. please take the time to look at all the screw and lock, make sure to secure all parts of your machine, run test all light before riding, Brake, Turn signal, All light even back up light.

 

 

WHEN CUTTING THE OEM TAIL RACK SUPPORT, CUT THREW THE WELDING, IN CASE YOU NEED TO WELDING BACK SOMEDAY

 

THANKS

Richard Pom From QC, CANADA

 

   

© Copyright 2008-09 RACK IN MOTION