Before
After
1. First, remove the seats, pipe,rear pegs,
disconnect all lights in the back,
2. Cut the undertray with a sharp knife or a
dremel (I suggest the last one)
3. you'll need thet plastic bracket to hold the rear tail but it has to be cut in half like shown here
4. This is very
important, all of the little tabs need to be trimmed absolutely flush
to the inside of the tail section, also the
middle attachement has to be trimmed flush too, the undertail will have 4
attachement now.
5. install the plastic bracket to the rear sub frame, temporarely install the tail and undertail, make the connections. The wire from the right side rear blinker has to pass over the stock undertray.
6. All connections are located on the rear left
side. For the tail lights,
the appropriate connections are the black wire from
the bike to the black and white to the lights, blue
to the red, and yellow 7. Connect the blinkers the same as stock.
8. Install two zip ties(or tie wraps) at each
end of the plastic bracket
9. secure all together, make final adjustments before installing the 4 plastic rivets that hold the undertail to the tail.
nice, sleek, effective and you still have trunk space!
note: tail lights now differ from the picture here you might want to get yourself a new flasher
relay because with have fun, Erik
© Copyright 2008-11 Mototeck Innovation |