Installation
Guide
Honda Cbr 929 00/01
Mototeck Undertail
|
Please
read these instructions from beginning to end before you start the
installation. Should you have any questions, please contact Rack in
Motion immediately. If you do not feel comfortable doing this job
yourself, it is suggested that you have an experienced Motorcycle
Technician perform the installation.
1. Place
the bike on a stand, preferably a swing arm stand.
2. Remove
the front seat.
3. Remove
the solo seat section or rear seat.
4. Remove
the lock rivets and Allen bolts under the tail.
5.
Disconnect the tail light wire and carefully remove the tail section.
6. Cut
the stock signal wires as close as possible to where the signal connects
to the turn signal wire.
7. FENDER
TRIMMING: IMPORTANT NOTE: The following procedure involves some cutting
of plastic. Use Safety Glasses for all cutting and/or grinding
procedures! The stock fender is used to retain the trunk area. You also
keep the holder clips for the support bar. The stock fender must be
trimmed enough to install the Undertail section. For cutting, I
recommend a Dremel Tool with a plastic cutting tip. I have used them
with very good results, but you can also use a Hack Saw blade or
something similar. You basically have to cut the fender at least as high
as the finished edge and also leave room for the signals. It's not
critical to cut perfectly since the new Undertail covers all of the cut
edges. Keep the two stock bolt connections on each side for more
support. See two pictures below to see what the results should look like.
|
9. Reinstall the tail section on the bike, but
do not install any of the bolts.
10.
Slide the Undertail up into the tail section and position the rear holes to
be drilled. After drilling the holes, install the four plastic fasteners.
You may have to remove the Slip-on to drill the holes on the right side.
11. Use the
lock clip for the key lock swift to reinstall the rear lock devise, install
the ring supply in the kit, like picture below.
picture
coming soon
12. Re-install the tail section.
13. Connect the Tail light and Turn signal wires. You must use the LED Tail
light bulbs that came with your Undertail. Check the signal, tail and brake
light operation.
14. It suggested that you install a heavy duty Turn signal relay. In most cases,
after installing LED's, the signals will flash at a very rapid rate. This
relay installed in place of the stock unit will return the Turn signal
flashing rate back to normal. We have these units in stock. Our Part Number
is 3100610.
15.
Install the license plate support by marking and drilling three holes for
the fasteners supplied. You can also use nuts and bolts if you prefer.
When you are finished, it
should look something like this!
© Copyright 2008-09 Rack in Motion
|