Note: instructions are the same for the 2002 and 2006 bikes. 1. Remove the seats, pipes,rear pegs,
disconnect all lights in the back, 1.
4. Then remove the key lock and reposition 2 relays outside of the sub frame on the left side and one on the right side using zip ties.(see pic 2. and 2.1)
2. 2.1
5. Cut the undertray with a sharp knife or a dremel (I suggest the last one) use safety glasses, be careful. look at the pictures below to guide you 3.1
6. Cut the sides flush to the box of the undertray . New location of the relays (blue arrow) Location of the keylock cable holder notch to snap the keylock cable note, wait before clipping the cable in the bracket. other views
7. Insert the cable in the keylock then press
the white plastic bushing 8. Insert the undertail and attach it on both
side with the 2 stainless 4.2 9. Drill on the flat area to install the licence plate bracket (provided in the kit), measure, mark and drill. 10. Connect the tail lights and turn signals as follow: Tail/brake lights: green from the bike (ground) to the black with white stripe on the tail light. black with brown stripe from the bike(running light) to the red on the tail light. green with yellow stipe from the bike (brake light) to the all black on the tail light. Turn signals:
© Copyright 2008-09 Rack in Motion |